Roofing & Exterior

Fence Installation & Repair in Beaumont, TX

Wood privacy, cedar, chain link, ranch and pipe fence, gates and storm repairs.

At a glance

The Short Answer

A typical backyard privacy fence takes two to four days, including time for the post concrete to set. We walk the line, get utility locates, set posts in concrete, and build in pine, cedar, chain link, ranch rail or pipe. A new fence inside Beaumont city limits usually needs a permit, and we pull it on the jobs we do.

Typical timeline
2 to 4 days for a typical backyard fence
Method
Posts set in concrete
Materials
Pine, cedar, chain link, ranch rail or pipe
Permit
Usually required inside Beaumont city limits
Windstorm (WPI-8)
Covers roofs, windows, doors, additions and new builds
Estimate
Free, in person, in writing

What should you know about fence installation here?

Every hurricane season takes down miles of fence in Southeast Texas, and every wet spring leans a few more. Rocha's General Construction builds new fences and repairs storm-damaged ones across Beaumont, Jefferson County, Orange County and Hardin County: wood privacy, cedar, chain link, ranch rail and welded pipe, plus the gates that go with them.

Tell us what the fence needs to do, keep a dog in, block a view, or hold cattle, and we will price the right build.

What goes into a fence job?

A fence here has three enemies: wind, water and rot. A six-foot privacy fence is a sail. When Rita, Ike and Laura came through, the fences that stayed up had deeper posts, set in concrete, with rails fastened on the correct side. The ones that fell usually had shallow posts or posts that had rotted at the ground line years earlier.

Flooding like Harvey and Imelda brings a different risk: posts that sit in standing water for days can lose their grip in saturated soil, and a run can lean once the water goes down.

Wet clay makes that worse. Our soils hold water after a rain and shrink hard in August. Posts that are not set deep enough work loose, and the fence starts to lean. We set posts deeper on taller fences and slope the concrete cap so water runs away from the wood.

Wood privacy fence is the most common job we get. Pine pickets are the budget choice. Cedar costs more and resists rot and insects better. Board-on-board gives full privacy even as the wood shrinks. Side-by-side pickets cost less and leave small gaps over time. For posts, we use pressure-treated wood rated for ground contact, or galvanized steel posts where you want longer life in wet ground.

Chain link works for dog runs, back lots and commercial property. We install galvanized or black vinyl-coated fabric with top rail and tension wire.

On acreage, from Lumberton and Silsbee up into Big Thicket country and out toward Mauriceville, ranch rail and welded pipe fence are popular. Pipe fence holds up to livestock and storms and looks clean along a road frontage.

Gates get the hardest use. We build walk gates and double drive gates with proper bracing so they do not sag, and we reset or rebuild gates that already have.

Fence repair is often the smarter call. If most of the fence is sound, we replace broken posts, rails and pickets and blend in the new wood.

The City of Beaumont requires a permit for residential fences, and we pull it on our jobs. Other towns and subdivisions have their own height rules and HOA standards, and we check those before we set a post.

Materials and methods

Pressure-treated ground-contact posts, galvanized steel line posts, pine and cedar pickets, treated rails, galvanized ring-shank nails and exterior screws, bagged concrete, chain link fabric, top rail, tension bands and fittings, drill pipe and sucker rod for pipe fence, welding rig for pipe work, heavy strap hinges and drop rods, post hole auger, string lines and levels.

How does a fence job run?

  1. We walk the fence line with you, mark corners and gates, and look for utility markers, drainage paths and trees.

  2. You get a written estimate that lists height, material, post type, post spacing and gate hardware.

  3. Before digging, we call in utility locates through Texas811 and pull any permit the city requires.

  4. Old fence comes down and gets hauled off. We set posts in concrete, let them cure, then hang rails and pickets or stretch fabric.

  5. Gates go in last so we can square them to the finished posts.

  6. We clean up the line, haul away scrap, and walk the finished fence with you.

Permits and inspections

Does a fence job need a permit?

A new fence inside Beaumont city limits usually needs a permit, and replacing a long run of fence can too. Height limits, setbacks and corner-lot sight lines decide where a fence can go and how tall it can be. We check the rules for your lot, and any deed or HOA limits you tell us about, before the first post goes in.

In Jefferson and Chambers counties, roof, window, door and addition work can also need a Texas Department of Insurance windstorm inspection during the job.

Why hire Rocha's General Construction?

We are local, and fence work after a storm is where local matters. We answer the phone, show up, and finish the line.

Your estimate spells out post depth, spacing and materials so you can compare bids honestly. We set posts to handle our wind and our clay, not just to pass a look from the street. And when a fence can be repaired instead of replaced, we tell you.

Pricing

What Moves the Price

How we price every job

Length and height

Linear feet of fence and how tall it runs set the post, rail and picket count.

Material

Pine costs less; cedar holds up better to rot and insects. Chain link and pipe are priced differently again.

Gates and the old fence

Braced gates and hardware, plus removing and hauling off the fence that is there now.

FAQ

Fence Installation & Repair FAQ

How long does a new fence take?

A typical backyard privacy fence takes two to four days, including time for post concrete to set. Longer runs, pipe fence and gates add time.

Pine or cedar?

Pine costs less. Cedar holds up better to rot and insects in our humidity and grays evenly if you leave it unstained. Both need good posts to last.

Do you repair storm-damaged fences?

Yes. We replace broken posts, rails and pickets and reset leaning sections. After a hurricane we take calls in the order they come in, so call early.

All FAQs

Related Services

All Roofing & Exterior services

Answered by Rocha's General Construction · Updated

Get a Free Fence Installation & Repair Estimate

Call 409-248-2534 or send the form and we will set up a time to look at the job.